| Arc Flash Forum https://brainfiller.com/arcflashforum/ |
|
| Open Delta in EasyPower https://brainfiller.com/arcflashforum/viewtopic.php?f=15&t=192 |
Page 1 of 1 |
| Author: | wbd [ Thu Aug 28, 2008 4:33 pm ] |
| Post subject: | Open Delta in EasyPower |
Hello, Has anyone done a open delta in EasyPower? Support says it can't be modeled but I was wondering if anyone has come with a work around that provides a reasonable answer. But this may also be a mute point for Arc Flash as it is a txf bank of a 75 & 15 kva txf at 240V. Technically this meets part of the exclusion in IEEE 1584 being less than 125 kva but is not less than 240V. Thoughts and comments appreciated. |
|
| Author: | Catcher13 [ Fri Aug 29, 2008 8:39 am ] |
| Post subject: | |
Probably is not worth considering < 125 kVA but you could perhaps fake it with a three phase which should be worse than your requirement. IEEE 1584 is only for three phase. |
|
| Page 1 of 1 | All times are UTC - 7 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|