| Arc Flash Forum https://brainfiller.com/arcflashforum/ |
|
| Insulating feeder wires/term points in a switchboard/panel https://brainfiller.com/arcflashforum/viewtopic.php?f=2&t=5648 |
Page 1 of 1 |
| Author: | wsorrell1970 [ Wed Jan 04, 2023 12:33 pm ] |
| Post subject: | Insulating feeder wires/term points in a switchboard/panel |
Hello, I was wondering if a Switchboard or Panelboard has its feeder wires insulated and termination points shielded with plastic/insulation, then the Arc Flash rating of the switchboard/panelboard should be the same as though nothing was insulated? The cal/cm2 number would not change. I'm thinking the insulation might protect against a shock, but not an Arc Flash explode. Just asking if this assumption is correct. |
|
| Page 1 of 1 | All times are UTC - 7 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|