Using the extension cord as a disconnect for a 1/2HP motor caused the cord to catch on fire. GFCI or circuit breaker feeding the cord did not trip. 120VAC.
| Attachments: |
|
File comment: Cord Fault IMG_0875.JPG [ 1.45 MiB | Viewed 25053 times ] |
| Arc Flash Forum https://brainfiller.com/arcflashforum/ |
|
| Extension Cord Fault https://brainfiller.com/arcflashforum/viewtopic.php?f=30&t=4377 |
Page 1 of 1 |
| Author: | PAult [ Tue Jun 20, 2017 9:38 am ] | ||
| Post subject: | Extension Cord Fault | ||
Using the extension cord as a disconnect for a 1/2HP motor caused the cord to catch on fire. GFCI or circuit breaker feeding the cord did not trip. 120VAC.
|
|||
| Author: | BarryB [ Mon Jun 26, 2017 8:21 am ] |
| Post subject: | Re: Extension Cord Fault |
Probably caused by excessive resistance at plug vs. over amperage. This would result in more heat than could normally be dissipated by the plug until it ignited. |
|
| Author: | JBD [ Mon Jun 26, 2017 8:28 am ] |
| Post subject: | Re: Extension Cord Fault |
BarryB wrote: Probably caused by excessive resistance at plug vs. over amperage. This would result in more heat than could normally be dissipated by the plug until it ignited. Yeah, and there appears to be little to no damage around the ground pin, so it looks like a GFCI might not have noticed this event at all. |
|
| Page 1 of 1 | All times are UTC - 7 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|