| Arc Flash Forum https://brainfiller.com/arcflashforum/ |
|
| Poll: Metal-enclosed Switchgear above 15-kV https://brainfiller.com/arcflashforum/viewtopic.php?f=4&t=3234 |
Page 1 of 1 |
| Author: | Matt780 [ Tue Mar 11, 2014 7:43 am ] |
| Post subject: | Poll: Metal-enclosed Switchgear above 15-kV |
Hello, I would like to take a small poll or begin a discussion on potential approaches to provide adequate PPE recommendations to personnel exposed to an arc flash hazard on metal-enclosed switchgear above 15-kV. |
|
| Author: | wbd [ Wed Mar 12, 2014 6:33 am ] |
| Post subject: | |
For industrial type facilities, I use EasyPower and it uses IEEE 1584 up to 15kV. Above 15kV, it uses Ralph Lee method. For substations and utility overhead lines, I use ArcPro. |
|
| Author: | Voltrael [ Wed Mar 12, 2014 8:41 am ] |
| Post subject: | |
Didn't answer the poll, as I currently only work up to 2300 kV, with the exception of two 46kV/2.3kV utility transformers, and I don't model the primaries on those transformers. |
|
| Author: | Jim Phillips (brainfiller) [ Sun Mar 16, 2014 12:33 pm ] |
| Post subject: | |
This poll has been moved to the Question of the Week. Please see [url='http://arcflashforum.brainfiller.com/threads/incident-energy-calculations-for-switchgear-above-15-kv.3242/#post-15031'][the new link][/url]for it. |
|
| Page 1 of 1 | All times are UTC - 7 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|