| Author |
Message |
|
wbd
|
Post subject: Open Delta in EasyPower  Posted: Thu Aug 28, 2008 4:33 pm |
|
| Plasma Level |
 |
Joined: Wed May 07, 2008 5:00 pm
Posts: 879
Location: Rutland, VT
|
|
Hello,
Has anyone done a open delta in EasyPower? Support says it can't be modeled but I was wondering if anyone has come with a work around that provides a reasonable answer.
But this may also be a mute point for Arc Flash as it is a txf bank of a 75 & 15 kva txf at 240V. Technically this meets part of the exclusion in IEEE 1584 being less than 125 kva but is not less than 240V.
Thoughts and comments appreciated.
_________________
Barry Donovan, P.E.
www.workplacesafetysolutions.com
|
|
| Top |
|
 |
|
Catcher13
|
Post subject: Posted: Fri Aug 29, 2008 8:39 am |
|
Joined: Sun Aug 05, 2007 5:00 pm
Posts: 21
|
|
Probably is not worth considering < 125 kVA but you could perhaps fake it with a three phase which should be worse than your requirement. IEEE 1584 is only for three phase.
|
|
| Top |
|
|
 
|
Page 1 of 1
|
[ 2 posts ] |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
