| Author |
Message |
|
Superman Engineer
|
Post subject: Relay Settings SKM  Posted: Fri Mar 16, 2012 1:07 pm |
|
Joined: Tue Jan 17, 2012 5:00 pm
Posts: 39
|
|
Hello Everyone!!
I am setting up relay settings for Multilin!!! How would I set-up time dial of relay in SKM?
Thank you in Advance!!
|
|
| Top |
|
 |
|
jghrist
|
Post subject: Posted: Fri Mar 16, 2012 8:11 pm |
|
Joined: Wed Jun 04, 2008 9:17 am
Posts: 428
Location: Spartanburg, South Carolina
|
|
Set it to coordinate with upstream and downstream overcurrent protective devices.
|
|
| Top |
|
|
|
nknfive
|
Post subject: Posted: Mon Mar 19, 2012 9:53 am |
|
Joined: Tue Jan 10, 2012 6:11 am
Posts: 3
|
|
Appreciate if you can put your question more specific.
If you know which model you are using, make sure you have them in your SKM library. Once you find them, try the settings tab in component editor.
Like you see in attachment, you need to give time dial setting for different curves (Norm Inverse, Very Inverse, Extreme inverse, etc.)
Hope this helps
|
|
| Top |
|
|
|
Superman Engineer
|
Post subject: Posted: Thu Mar 22, 2012 10:10 am |
|
Joined: Tue Jan 17, 2012 5:00 pm
Posts: 39
|
|
Thanks for your advice!! Thanks for you help nknfive!! It was wired to see the curve and Time dial was actually in Settings 1. !!!
I am use to of ETAP so it was quite wired to see the way things are presented in SKM!!!
|
|
| Top |
|
|
 
|
Page 1 of 1
|
[ 4 posts ] |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
